Prices for Servicing

          Boiler Service
          Fire
          Unvented Water Cylinder
          Boiler + Water Cylinder
          Boiler + Fire
          Boiler + Fire + Water Cylinder
          Fire + Back Boiler
          Plus Landlord's Certificate                
Mains Gas

£60
£60
£45
£80
£80
£120
£80
£10
LPG

£72
£72
£72
£90
£90
£150
£90
£15










          Underfloor Heating
​          Underfloor Heating + Water Heater
£105
£120​
*  Please note:  there may be a need to replace faulty or damaged parts.  These will not be included in the above prices but a quote will be given at the time of the service.  VAT will be added to above prices.

Boiler Service Checklist

  • A visual check to ensure your boiler still meets current standards
  • Fire up the boiler to identify any faults
  • Casing removed to check all main components including heat exchanger, spark/sensor probe, main injector, heat exchanger
  • Ensure the flue terminals are not obstructed and the internal flue components are sealed properly
  • Flue gas analysis to check that there is no build up of carbon monoxide in the appliance
  • Gas valve adjusted to check that burner is combusting properly and efficiently
  • Clean the inside casing surfaces and boiler parts if necessary
  • Check gas tightness to ensure there are no leaks
  • Replace the boiler casing and check it's properly sealed
  • Provide a service report that shows all the necessary checks have been made

          LPG Boilers service includes all of the above, plus:
  • Check the governor
  • Check the age and condition of the hoses on the bottles

Unvented Water Cyclinder Checklist

  • Test the expansion relief valve for the correct function and that it closes after use
  • Test the temperature and pressure relief valve for the correct function and that it closes after use
  • Drain the water storage tank as needed to below the level of the combination valve/pressure reduction valve
  • Strip the combination valve/pressure reduction valve and clean the line strainer inside
  • Take the pressure of the expansion vessel if one is installed 
  • Top up the pressure on the expansion vessel if required
  • Check for leaks
  • Test the function of the main + boost immersion heaters
  • Test the function of the main and boost thermostats
  • Take a resistance across the main and boost immersion heater elements
  • Check that an electrical connection to earth is present
  • Sign a service record